User Guide

11 OTHER FUNCTIONS

D Cloning using a personal computer

Data can be cloned to and from a personal computer (Mi-

crosoft

Windows

98/2000/Me/XP) using the optional CS-208

CLONING SOFTWARE

and the optional cloning cable OPC-478U

(USB type) or OPC-478 (RS-232C type). Consult the CS-208

CLONING SOFTWARE

HELP ﬁle for details.

D Cloning error

☞ NOTE: DO NOT push any key on the sub-transceiver dur-

ing cloning. This will cause a cloning error.

When the display as below appears, a cloning error has oc-

curred.

In such a case, both transceivers automatically return to the

clone standby condition and cloning must be repeated.

■ Packet operation

D Data speed

For packet operation, the transceiver can be set to one of two

data speeds: 1200 bps or 9600 bps.

q While pushing

[SET•LOCK],

push [PWR] for 1 sec. to enter

initial set mode.

w Push

[SET•LOCK]

or [S.MW•MW] to select the ‘BPS’ item.

e Rotate [DIAL] to select the desired data speed.

r Push

[PWR]

to exit initial set mode.

For 1200 bps operation—

• Disconnect the microphone plug from the microphone

connector during data transmission, otherwise the data

signal and voice signal are simultaneously transmitted.

For 9600 bps operation—

• When the transceiver is set for 9600 bps data transmis-

sion in set mode, the microphone signal is automatically

cut. Therefore, it is not necessary to disconnect the mi-

crophone plug from the connector in this case.

•

When pushing [PTT] during data transmission, data trans-

mission is interrupted and voice signals have priority.