Operation Manual

16
5
SCAN OPERATION
■ Scan types
The U.S.A. version has 3 scan types to suit your needs. The
non-U.S.A. versions have 2 scan types.
■ COM band scan
q Push [CLR•DEL] to select the frequency mode.
w Push [SQL•
WX-ALERT], then rotate [DIAL] to set the
squelch level to the point where noise is just muted.
e Push , then push [ANL•
SCAN] to start the scan.
• When a signal is received, the scan pauses until it disappears.
• To change the scanning direction, rotate [DIAL].
r To stop the scan, push [CLR•DEL
].
■ Memory scan
q Push [MR•MW] to select memory mode.
•Push , then push [0•
BANK], and rotate [DIAL] to select the
BANK number if desired. Push [CLR•
DEL] to exit the BANK se-
lection mode.
w Push [SQL•WX-ALERT], then rotate [DIAL] to set the
squelch level to the point where noise is just muted.
e Push , then push [ANL•
SCAN] to start the scan.
• When a signal is received, the scan pauses until it disappears.
• To change the scanning direction, rotate [DIAL].
r To stop the scan, push [CLR•DEL].
NOTE: Program 2 or more memory channels to start
memory scan.
WEATHER CHANNEL SCAN
Repeatedly scans all “TAG” weather channels. Weather
channels are available for the U.S.A. version only.
MEMORY SCAN
Repeatedly scans se-
lected memory bank’s all
“TAG” memory chan-
nels. Used for checking
often-used channels and
bypassing usually busy
channels such as con-
trol-tower frequencies.
COM BAND SCAN
Repeatedly scans
all frequencies
over the entire
COM band.
108.00
MHz
Scan
Jump
118.00
MHz
136.975
MHz
non-TAG
channel
non-TAG channel
Mch 2 Mch 4 Mch 6
Mch 7Mch 1
Mch 8Mch 10Mch 19
4
5