Operation Manual

9-8
Tone scan
The transceiver can detect subaudible tones in a re-
ceived signal. By monitoring a signal that is being
transmitted on a repeater input frequency, you can de-
termine the tone frequency required to access the re-
peater.
q Set the desired frequency or memory channel to be
checked for a tone frequency.
w Push [AM/FM] several times to select FM mode.
e Push [TONE] for 1 sec. to enter tone frequency
screen.
r Push [F-1Y] or [F-2Z] to check the repeater tone
frequency or tone squelch frequency, respectively.
t Push [F-6T-SCAN] to start the tone scan.
•“SCAN blinks while scanning.
y When the tone frequency is detected, the tone scan
pauses.
The tone frequency is set temporarily on a memory
channel. Program into the memory channel to store the
tone frequency permanently.
The decoded tone frequency is used for the repeater
tone frequency or tone squelch frequency.
u To stop the scan, push [F-6T-SCAN].
Push [F-4DEF] for 1 sec. to select the default frequency.
i Push [EXIT/SET] to exit tone frequency screen.
[F-1Y] [F-2Z]
[TONE]
[F-6T-SCAN][F-4DEF]
[EXIT/SET]
9
SCANS