Operation Manual

6-4
■
∂∂
TX function
The ∂TX function shifts the transmit frequency up to
±9.999 kHz in 1 Hz steps (10 Hz steps when cancelling
the 1 Hz step readout) without moving the receive fre-
quency.
• See (3 on p. 1-11 for function description.
q Push [∂TX].
•“ ” appears.
w Rotate [RIT/∂TX].
e To reset the ∂TX frequency, push [CLEAR] for
1 sec.
• Push [CLEAR] momentarily to reset the RIT frequency
when the quick RIT/∂TX clear function is ON. (p. 12-1)
r To cancel the ∂TX function, push [∂TX] again.
•“ ” disappears.
DD ∂∂
TX monitor function
When the ∂TX function is ON, pushing and holding
[XFC] allows you to monitor the operating frequency
directly (∂TX is temporarily cancelled).
✔ For your convenience— Calculate function
The shift frequency of the ∂TX function can be
added/subtracted to the displayed frequency.
➥ While displaying the ∂TX shift frequency, push
[∂TX] for 1 sec.
■ Monitor function
The monitor function allows you to monitor your trans-
mit IF signals in any mode. Use this to check voice
characteristics while adjusting SSB transmit parame-
ter. (p. 12-4) The CW sidetone functions regardless of
the [MONI] switch setting.
q Push [MONI] to switch the monitor function ON and
OFF.
• [MONI] indicator above this switch lights green.
w Rotate [MONI GAIN] for the clearest audio output
while pushing [PTT] and speaking into the micro-
phone.
NOTE: When using the VOX voice delay, turn the
monitor function OFF; or transmitted audio will be
echoed.
[MONI GAIN][MONI]
[XFC]
[RIT/∂TX] [∂TX]
[CLEAR]
6
FUNCTIONS FOR TRANSMIT