1 the terminals: have:polarity; be sure o make the correct connection. Note tither keyed: voltage when switching. With' semiconductor foreplay with resistors in the circuit) should be adjusted to be below 0.4 Vols! 3:9 RITZY Wise: operating RATTY, connect the: ACC socket ions 8 {ground) and 914 var teletypewriter thirtieth s ti spiel retry or a level ‘carter Yo TTL level, and the tones for your terminal unit will available! from pin 4.
sin the RF position. 39, METER: SWITCH. When the METER SELECT switch oni the grant panels in the RE position, this switch Is used to select indication of the: escalator: torrent: bl the: final Transistors: ot relative GULPER power: 40, CW: DELAY CONTROL operation; this.controls the transmit/receive switchover time-delay. ! Adjust to'suit your Keying speed. Note: {f the delay is set 1o the shortest position, it will food almost full bra akin CW.
4B VED s for both transmitting {HAM: bands only find receiving and s chiseled by placing the! VEQ switch el U8 position i The nitration: and receive frequency. Wilt s dogtrotted by BT VEQ; displayed: on the e quench readout; freestanding B2 mammary. EXAMPLE: ‘When the'set is turned ON 7. 100.0 will be displayed 'on' the readout. This will dour whether the VEQ switch is neither the 1A% o B Rotating 1he tuning knob: clockwise will increase.
INFREQUENCE display. In:888 operation: there s both an: USB {upper side band} and an L3B (lower: side:band). & USB s selected on the MHz band and above, and LSE on the 9MH2 band and Below, initiate NOBS setting. When vou wish ta operate gn. the opposite’ side band, push the FUNCTION switch first, then S5B switch, Vi hen vou wish 16 operate ona band other than the MHz husbandman the BAND! UP/DOWN switches Yo select the band vou wish to-operate.
sections: i Before’ performing any Wbk o0 the et make sure that the power cord is detach from the transceiver. 1i:Ramove the bottom cover: 2. Remove the fol screws gt sate end of the IF Unit. Tilt the unit back: toward vou, being careful not to damage the caskets and plugs that are installed on'the 1F Unit 8. Change the 2 Pin plug inserted in 41,4 Pin ask, of the RE unit, tithe right side of J1 the next 2 Topping the previous noise) as shown. 4 Carefullywreplsce the IF unit and the bottom cover.
