USB Driver Installation Guide

Windows Vista

DRIVER INSTALLATION

The displayed dialogue boxes, indications or oper-

ations may differ slightly from the following instruc-

tions according to your system conditions or envi-

ronment.

Make sure that the transceiver is not connected to

the PC.

w Start up Windows.

• Quit all other application if running.

e Double-click the “WinVista” folder.

• The folder construction: “7200UsbDrv_v100” ➞

“Driver” ➞ “WinVista”

Double click

r Double-click the “CP210xVCPInstaller.exe” to start

up the USB driver installer.

Double click

t “A program needs your permission to continue” dia-

logue box appears as below.

Click [Continue].

Click

y Verify the installation location, then click [Install].

Click

u Windows starts scanning for the system, then starts

installing the USB driver.

i After the installation is completed, click [OK].

• Restarting the PC is recommended.

Click

NOTE:

• NEVER connect the transceiver to the PC with the USB cable (third party) until the USB driver installation

has been completed.

• The USB driver for Windows Vista does not support the automatic recognition system.

☞ Continues to the next page