HM-56 ADVANCED FUNCTIONS The HM-56 HAND MICROPHONE is equipped with 14 MDT code memory channels and a re-dialing function for auto dialing. Up to 22-digit telephone number, etc. can be memorized into each memory channel. NOTE: Set [LOCK] on the microphone to the OFF position to use HM-56 functions. BM 3 modes The HM-56 has 3 modes as follows: * MEMORY WRITING mode Used when writing MDT codes into a MDT code memory channel. « The active indicator blinks fast.
HB MDT code memory erasing 1) Push [MW] on the microphone to select MEMORY WRITING mode. + The active indicator blinks. 2) While holding the PTT switch, push the desired MDT code memory number the keyboard. Push and hold the PTT (Zr Push desired MDT code switch. memory number. 3) Release the PTT switch to erase the MDT code. 4) Push [MW] on the microphone to return to normal use. HM-56 ADVANCED FUNCTIONS HB Transmitting a MDT code memory Programmed MDT code memory contents are automatically transmitted.
HM-56 ADVANCED FUNCTIONS HB Re-dialing function To allow you to trey-smit a previously transmitted MDT code the re-dial memory channel automatically memorizes the last transmitted MDT code sequences. * Manual re-dialing The last-transmitted MDT code can be transmitted by manual key operation. 1) Push and hold the PTT switch. 2) Push [RD] to transmit the last-transmitted MDT codes. * The active indicator blinks according to the MDT code length. switch, @ Push [RD].
HB 1750 Hz tone call Using the HM-56, you can access a repeater that requires a 1750 Hz tone. 1) Push [MR] on the microphone. » The active indicator lights. 2) Transmit a 1750 Hz tone as follows: Push and hold to transmit a 1750 Hz tone continuously. Push [3%] to transmit a 1750 Hz tone for approx. 0.5 sec. 3) Push [MR] again to cancel the function. * The active indicator goes out. Push [#1] to transmit a Push [=k] to transmit a 1750 Hz tone continuously. 1750 Hz tone for approx. 0.5 sec. . IMPAIR.
