IMPORTANT This receiver unit is 'a SUPPLEMENTAL AlD TO NAVIGATION ONLY and is not intended to be a substitute for accurate and current nautical saris. READ THIS INSTRUCTION MANUAL CAREFULLY before attempting to operate the receiver unit. SAVE THIS INSTRUCTION MANUAL This instruction manual-contains important safety and operating instructions for the GP-2000.
1 __PANEL DESCRIPTION B Front panel aRs Rec Ever SRT GPS2000 @ HATCH COVER Initial seating switches are located under this cover.
U| 2 INITIAL SETTINGS B Datum selection Datum |s: a coordinate ‘system with an associated ellipsoid ‘upon which a given :chart 'ig based.
CONNECTIONS AND INSTALLATION 3 B System connection CAUTION: Be tore connecting the GP:2000 to:the following: devices, be sure the prows switches of all devices are muted OFF. The: power cable: from: must be connected 1o the battery directly. | NEVER ; connect it to the [PWR OUCH terminal on the GP-2000° RECEIVER UNIT rear panel of the GP-2000. B GR-2000 ANTENNA For SE Blare Supplied antenna cable. {ORG-25% Personal computer.
3 CONNECTIONS AND INSTALLATION [ Mounting the receiver unit * Mounting locations Nonclinical 'settings have been 'mads; the GP-2000: doss. not require further adjustment. Thus: you need not install the receiver unit in an easy-to-get-to location: Choose the best location, within the range of the connected cable length; from: a: display device.
B Mounting the antenna unit CONNECTIONS AND INSTALLATION 3 * Mounting locations . Sheri selecting a mounting location, remember. the following: < Highs mounting locations obtain:better equals ity signals from satellites. Choose a location at least 4 m (13 feet) away: from other transceiver antennas. = Choose a location at'least 5'm (16 feel) away from antimacassar antenna: Be sure the location is out of range of vertical radar beams. The usual vertical bairn of ‘& radar s 307 40°.
| n Troubleshoot 4 MAINTENANCE L * Power does not common; nested. « Blown fuse. * Power: cable is improperly con: o ‘Reconnect the cable securely. » Check: for cause; then replace the fuse with:a spare one. » Power of the: GP-2000 does not « The [POWER] switch is in the » Push [POWER] fo tum the power applying power. turn: QFF ‘even though the con "ON” position, OFE. nested display device is: turned The [POWER] switch: on’ the 'GP-2000 OFF.
« Receive frequency « Helve sensitivity « Antenna impedance * Receive system » Number of satellites tracked « Accuracy « Acquisition and tracking * Memory data storage * Power requirement * Power consumption . Dimensions » Weight » Usable temperature range * AMEN 0183 sentence format SPECIFICATIONS D 11157542 MHz: G/A code riles than =130 dBm’ 1800 Multichannel multiplexed 38 Data outputs from 5 satellites cut of the 8: 2 Position: 15 m RMS* Velocity: 0.
