Tuzio® Blenheim Towel Warmer Installation Guide Code: W2093 / W2097 29.5” x 64.5” Hardwired Technical Helpline: Toll-Free 1-877-757-8990 www.icocanada.
Towel Warmer Installation Procedure 1 Rough-in Requirements (see figure 3) 1. The incoming power feed goes to a deep single gang electrical box (for timer). This electrical box can be located anywhere in the room, although we recommend it be alongside your light switches. 2. A power feed then goes from the timer electrical box to a single gang electrical box (for Towel Warmer). The location of this electrical box governs the location of your Towel Warmer (see fig. 2). 3.
Specifications & Drawings Model # Description Finish Weight (lb) Element Size W2093 Blenheim Electric Hardwire Chrome 67.0 W2097 Blenheim Electric Hardwire OR Bronze 67.0 Output WxH (mm) WxH (Inches) Metal Type 450W 5252Btu 750 x 1640 29.5” x 64.5” Mild Steel 450W 5252Btu 750 x 1640 29.5” x 64.5” Mild Steel Heating Element Specifications: 450 watt, 29.
Timer Installation Procedure 1 Installation 1 2 Install the timer as shown in figure 3. Apply power at the circuit breaker. 5 Programming You can set up to 7 programs. To set a program, you need to enter its start time (ON) and its end time (OFF). 1 2 Power On 2 1 Pry the switch door open from the bottom using a small screwdriver. 2 Ensure the ON/OFF selector is set to ON. Reset the switch using a 3 paperclip. 0:00 and MO will flash. 3 Setting the Clock 1 Set the time using the HOUR and MIN buttons.
