Installation Guide

877 757 8930
INSTALLATION INSTRUCTIONS
1. Check all items have been received.
1. Towel Warmer
2. Fixings Kit
2. Fix wall supports “A” to the wall using the screws provided and
in locations as shown on figure 2.
3. Hang and adjust the Towel Warmer using set screws “B” to lock
stud “C” in the wallbracket “A”. Ensure the Towel Warmer is
firmly and safely fixed.
PLUG-IN CONNECTION
TURN OFF POWER SUPPLY BEFORE PROCEEDING
1. Turn off power supply.
Plug connector in.2.
3. Switch on power supply.
1
2
3
ROUGH-IN REQUIREMENTS
1. Your towel warmer requires 110V GFCI protected power. This 110V receptacle should be
located no further than 18” from the electric plug-in exit location (see figure 2), and not
above the electric plug-in exit location.
2. Wall studs or plywood backing is recommended in the wall at all bracket
locations. See Fig 2 for bracket locations.
PRODUCT REGISTRATION
Once installation is complete (and within 60 days of purchase) register your product
online to activate your two year warranty. To register visit www.shopicobath.com, click on
resources then register your towel warmer or visit www.shopicobath.com/en/warranty.
Be sure to have your serial number (7 digit number on silver label at bottom right of towel
warmer) along with the date you purchased your towel warmer.
4
[e-mail] | www.icobath.com
Kontour Square Towel Warmer Installation Guide
Code: K6013E / K6014E
24” x 27” Plug-In
Warning: In case of damage or failure of the Towel Warmer the unit should be returned to the manufacturer or their
distributor. The warranty of 2 years on the Towel Warmer is NOT VALID in case of improper use or installation. Product
is designed for use within Canada and the United States only.
Do not connect the Towel Warmer to the power supply until all instructions have been read and
installation carried out in accord with them. Your towel warmer is 100W (110V) and conforms to CSA
standards (File ref: 2422531). Please ensure the CSA label is visible.