User's Guide

© IceRobotics Ltd 2015 Page 25 Release 1.1 2016
11
Compliance Information
FCC Compliance Information and Notice to Users
FCC ID: WWP-I-HUB
FCC ID: WWP-I-QUBE
This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment to an outlet on a circuit different from that to which the receiver is
connected.
Contact IceRobotics for help
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation. See 47 CFR Sec.
15.19(a)(3).
IceRobotics has not approved any changes or modifications to this device by the user. Any changes
or modifications could void the user’s authority to operate the equipment. See 47 CFR Sec. 15.21.
The IceHub is designed to operate with the two antennas shown below:
Use with ANY other antennas invalidates the FCC certification. Per FCC 15.203, the system must be
professionally installed and the installer has the responsibility to ensure that the correct antennas are
used.