Installation Guide

20
Remote Specificaons
S-20 RF
Remote Controller
Item
Type of Equipment
Rated Power Supply
Operang Frequency
Modulaon Type
Ambient Temperature Range
FSK
DC 4.5V
2422MHz
37.4°F - 104°F ( 3°C - 40°C )
This device complies with Part 15 of the FCC Rules. Operaon is subject to the following two condions: 1.) This device may not
cause harmful interference, and 2.) this device must accept any interference received, including interference that may cause
undesired operaons.
Adjusting the Remote Control Frequency
It may be necessary to adjust the remote frequency channel in homes where two or more
units are installed in close proximity. If two units are being acvated by a single remote,
follow the steps below to adjust the frequency on one remote.
1. Turn the unit off and unplug the power cord.
2. Locate the control panel on the side of the seat (pictured below).
3. Press and hold REAR WASH and STOP simultaneously.
4. Connue to hold REAR WASH and STOP while plugging the power cord back in
and hold REAR WASH / STOP for another 4 seconds.
5. The POWER ON LED light should start flickering and you should hear a repeang
beep sound, at which point you can release the REAR WASH and STOP buons on the
side panel.
Press and hold while plugging the
unit back in unl the POWER ON
LED starts flickering.
Connued on next page