Data Sheet

4
ELECTRONIC CONTROL
The device is equipped with a multi-level battery monitor that protects your vehicle battery against
excessive discharging when the device is connected to the on-board DC supply.
If the cooler is operated when the vehicle ignition is switched off, the cooler switches off
automatically as soon as the supply voltage falls below a set level. The cooler will switch back
on once the battery has been recharged to the restart voltage level. The compressor will start up
again automatically in a few minute when the voltage goes back to normal values.
Note: these values are measured at control unit input and/or on the DC socket.
NOTICE! DANGER OF DAMAGE!
When switched off by the battery monitor, the battery will no longer be fully charged. Avoid
starting repeatedly or operating current consumers without longer charging phases. Ensure that
the battery is recharged.
BATTERY PROTECTION LEVEL
It is possible to set three different battery protection threshold levels:
VOLTAGE
DISPLAY
12V 24V
PROTECTION
POSITION
LOW
1 Bar
9.4 10.4 21.1 22.7
MIDDLE
2 Bars
10.9 12.0 22.0 23.6
HIGH
3 Bars
11.6 12.7 24.0 25.6
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) This device
must accept any interference, including interference that may cause undesired operation of the device.
Le présentappareilestconforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
L'exploitationestautorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareildoit accepter tout brouillageradioélectriquesubi, mêmesi le brouillageest susceptible
d'encompromettre le fonctionnement.