Owner's Manual

ManualsBrandsIce-O-Matic ManualsPearl (Nugget) IceIce-O-Matic 273 Lbs. Pearl Ice and Water Dispenser

OPERATING INSTRUCTIONS

INITIAL START UP

After having correctly installed the ice machine and

completed the plumbing and electrical

connections, perform the following “Start-up”

procedure.

Remove the control board inspection panel and

cover to view the lights on the control board.

A. Open the water supply line shutoff valve and

turn the main switch on the power supply line to

the ON position.

The GREEN LED will glow to signal that unit is

under power.

NOTE: Every time the unit is turned on after being

shut off for a period of time, the 2nd RED LED will

blink for 3 minutes.

B. After 3 minutes have elapsed – the stand by

period – the unit starts operating by activating

systems in following sequence:

1. GEAR MOTOR

2. COMPRESSOR

3. FAN MOTOR – which is controlled by the

condenser temperature sensor. The probe is

within the condenser fins.

4. 2

RED LED switches off (Fig. 2).

C. Two or three minutes after compressor start up;

cubelet ice should begin dropping off the ice spout

into the storage bin.

GEMD270A

Page 8

Fig 1

Bin full

Bin empty

Reset button

Hi cond temp when Steady

3 minute wait when Blinking

No water

Power

Auger Motor when Steady

Hi evap temp when Blinking

Fig 2