Service Manual

ELEVATION SERIES CIM CUBER PURGE VALVE

4 3

Purge Valve

Operation

The Purge Valve is located in the back of the

Evaporator. The Valve should open when

energized by Relay 5 on the Board (LED ON)

during the Harvest Cycle to help empty the

mineral laden water (see Sequence of Opera-

tion pg. 9) and during the Cleaning/Sanitizing

Cycle (see Cleaning Instructions pg. 56).

Troubleshooting

The Purge Valve is located in the back of the Evaporator. The Valve should open when energized

by Relay 5 on the Board (LED ON) during the Harvest Cycle to help empty the mineral laden

water and during the Cleaning/Sanitizing Cycle. If Purge Valve fails to open with Relay 5 LED illu-

minated, unplug Connector at coil of Valve and check for line voltage. If none is found, check

output voltage at Molex at Board between Pink and Blue wires. If no voltage is found, the Board

is the issue. If output voltage is found, wiring between Molex and connector at Valve is the issue.

Voltage can also be verified at the connector at the coil on the Purge Valve.

R1 R2 R3

L2/N L1