User's Manual

34
and matching functions need to be performed to make the air filter work normally.
5.15 Fuel Pump
After the fuel pump is disassembled, repaired or replaced, it may cause the fuel pump to
be unable to continuously provide fuel to the fuel injection nozzle. At this time, the function
needs to be executed to activate the replaced fuel pump so that the car can start to inject fuel
normally and make the engine achieve the ideal Running status.
5.16 Engine Idle
This correction can be executed when the idle speed fault is resolved. Adjust the engine
speed of the car at idle speed.
5.17 Body stability
Learning and calibration after replacing the body stability control unit and other related
components, such as: lateral acceleration sensor for active roll stabilization system, BAS
brake assist system, ESP electronic stability program, calibration of yaw rate / lateral and
longitudinal acceleration sensors, pedal angle Sensors, etc.
5.18 Door
After repairing or replacing the window lift motor, it is necessary to perform relevant
functions for calibration.
 Door Window Calibration:
This routine learns the top position of the door window glass, which enables pinch
protection and one touch up function. The door window glass position can be learned by
executing this routine.
5.19 Seat
After repairing or replacing the seat position drive motor, it is necessary to perform
relevant functions for calibration.
 Driver's Seat Calibration:
The routine will restore all the seat axis position values to default for the driver's
seat module.
 Passenger's Seat Calibration:
The routine will restore all the seat axis position values to default for the passenger
seat module.
NOTE