Users Manual Part 2

CR Legend User Manual

Note: Do not place the device close to several sensors at the same time, or the

diagnostic tool will detect more sensors, which may result in programming failure.

Method 1 – Auto Create

This function is designed to program the specific sensor by applying random IDs

created according to the test vehicle when it is unable to obtain the original

sensor ID.

1. Select the wheel which needs to be programmed on the tool, place a sensor

close to the TPMS antenna of the tool, and tap Auto to create a new random

sensor ID.

2. Tap Program to write in the new created sensor ID to the sensor. The tool

starts programming until the programming process is finished.

Note: If Auto is selected, the TPMS Relearn operation needs to be performed after

programming all required sensors.

Method 2 – Manual Create

This function allows users to manually enter sensor ID. Users can enter the

random ID or the original sensor ID, if it is available.

1. Select the wheel which needs to be programmed on the tool, place the

sensor close to the TPMS antenna of the tool, and tap Manual.

2. Use the on-screen virtual keypad to input a random or original (if available)

sensor ID and tap OK.

Note: Do not enter the same ID for each sensor.

3. Follow the on-screen prompts to write in the sensor ID to the sensor.

Notes:

•

If a random ID is entered, please perform the TPMS Relearn function after

programming is finished. If the original ID is entered, there is no need to perform

Relearn function.

•

If a vehicle does not support Learn function, please select the Manual option to

enter the original sensor ID manually, or trigger the original sensor at the activation

screen to get its information, before programming the sensor.

Method 3 – Copy by Activation

This function allows users to wri

te in the retrieved original sensor data to the

specific sensor. It is used after the original sensor is triggered.

1. From the activation screen, select the specific wheel position and trigger the

original sensor. After the information is retrieved, it will be displayed on the

screen.