Users Manual Part 1

CR Legend User Manual
3
Memory: 4GB
Storage: 64GB
Screen: 5.99 inch capacitive touch screen with a resolution of 1440 x 720 pixels
Camera: Rear-facing 8.0MP camera
Wi-Fi: 2.4GHz/5GHz dual band
Connectivity:

DB15 Diagnostic connector

USB Type A port x 1 + USB Type C port
 Circular Connector for battery tester clamps
Working temperature: 0 ~ 45
Storage temperature: -10 ~ 60
2 Initial Use
2.1 Charging & Turning On
1. Plug one end of the included USB cable into the USB Type C port of the tool,
and the other end to the DC external power adaptor.
2. Plug the other end of the power adaptor to the AC outlet to start charging.
3. Press the POWER button to turn the tool on.
Caution: Please use the included power adaptor to charge your tool. No
responsibility can be assumed for any damage or loss caused as a result of using power
adaptors other than the one supplied.
Note: If the battery remains unused for a long period of time or the battery is
completely discharged, it is normal that the tool will not power on while being charged.
Please charge it for a period of 5 minutes and then turn it on.
2.2 Printer Setting
The tool has a built-in printer available for printing reports or screenshots. The
printer applies thermal paper roll with size of 30×57mm. Follow the steps
described as below to load it.
1. Dig your finger from the gap and lift it up gently until the printer cover is
opened.