Instruction Manual

138
Parameter Function
Send Email If you enabled this function, System can send out an
email to alert you when an alarm occurs.
Tour You need to check the box here to enable this function.
System begins 1-wiindow or multiple-window tour display
among the channel(s) you set to record when an alarm
occurs.
Please go to chapter 5.3.9 to set tour interval and tour
mode.
PTZ Activation Here you can set PTZ movement when alarm occurs.
Such as go to preset X.
7.8.3.2.2 Net Alarm
The network alarm interface is shown as in Figure 7-47.
Network alarm refers to the alarm signal from the network. System does not anti-dither and
sensor type setup. For reset setups, please refer to chapter 7.8.3.2.1.
Figure 7-47
7.8.3.2.3 Alarm Out
Here you can set alarm output channel mode. See Figure 7-48.
Figure 7-48
7.8.3.3 Abnormity