Instruction Manual

135
Video Matrix This function is for motion detect only. Check the box here to
enable video matrix function. Right now system supports one-
channel tour function. System takes “first come and first serve”
principle to deal with the activated tour. System will process the
new tour when a new alarm occurs after previous alarm ended.
Otherwise it restores the previous output status before the alarm
activation.
7.8.3.1.2 Video Loss
The video loss interface is shown as in Figure 7-42.
After analysis video, system can generate a video loss alarm when the detected moving signal
reached the sensitivity you set here.
Please note video loss does not support anti-dither, sensitivity, region setup. For rest setups,
please refer to chapter 7.8.3.1.1 motion detect for detailed information.
Figure 7-42
7.8.3.1.3 Camera Masking
The camera masking interface is shown as in Figure 7-43.
After analysis video, system can generate a camera masking alarm when the detected moving
signal reached the sensitivity you set here.
For detailed setups, please refer to chapter 7.8.3.1.1 motion detect for detailed information.
Figure 7-43