Manual

8
Figure 2-3
The rear panel is shown as below. See Figure 2-4.
Figure 2-4
Please refer to the following sheet for front panel button information.
SN Name Function
1 Remote control signal
receive window.
It is to receive the signal from the remote
control.
2 HDD indication light The light is on when systems is reading or
write the HDD data.
3 Power indication light The light is on when the device is connected to
the power.
4/5 USB port /
When the device is off, press it for a long time
to boot up the device.
When the device is on press it for a long time
to shut down the device.
6 On/off button
When the device is off, press it for a short time
to close/open the screen.
7 Network status indication
light
/
8 Power socket port Connect to DC 12V power
9 Cable port Video CVBS input, audio CVBS input, video
CVBS output, audio CVBS output, RJ45 port.
10 Power socket Alarm input, alarm output, RJ-45 port, RS-232
port.