Manual

65
key in the remote control).
Click Pan/Tilt/Zoom, the interface is shown as below. See Figure 4-67.
Here you can set the following items:
 Step: value ranges fro 1 to 8.
 Zoom
 Focus
 Iris
Please click icon and to adjust zoom, focus and iris.
Figure 4-67
In Figure 4-67, please click direction arrows to adjust PTZ position. There are total 8 direction
arrows.
Figure 4-68
Here is a sheet for you reference.
Name Function
key
function Shortcut
key
Function
key
function Shortcut
Key
Zoom Wide Far

Focus Near
│
││
│ 
Far
► │
││
│
Iris Close ⊳ Open 
4.7.9 Display
Display setup interface is shown as below. See Figure 4-69.
 Transparency: Here is for you to adjust transparency. The value ranges from 128 to 255.
 Channel name: Here is for you to set local or remote network camera channel name. System
max support 25-digit (The value may vary due to different series).
 Time display: You can select to display time or not when system is playback.
 Car number display: You can select to display plate number or not when system is playback.
 GPS display: System displays GPS information in the screen for your reference. Please note
only the unit of GPS module supports this function.
 Resolution: There are four options: 1280×1024, 1280×720, 1024×768,800×600(default).
Please note system needs to reboot to active current setup.
 Enable tour: activate tour function.