Manual

97
Parameter Function
Light/wiper
You can control the light and wiper of the peripheral device via
RS485 (RS-485) command. Please note the peripheral device shall
support this function.
6.2.5 Color and More Setup
Color and other setup interface are shown as in Figure 6-12.
Figure 6-12 Color
Please refer to the following sheet for detailed information.
Parameter Function
Video
setup
It is to adjust monitor video
brightness.
Note:
All the operation here
applies to WEB end only.
It is to adjust monitor video contrast
ness.
It is to adjust monitor video
saturation.
It is to adjust monitor video hue.
Reset
Restore system default value.
Click more button, the interface is shown as in Figure 6-13.
Figure 6-13 Color and More
Please refer to the following sheet for detailed information.
Parameter Function
More
Picture
Path
Click picture path button, system pops up an interface for you
to modify path.