Instruction Manual

Move the cursor to SITE INFORMATION and then click confirm button.

z ADDR TYPE: There are two options: soft and hard. Please use the left/right button on the keyboard or

in the speed dome terminal menu to set. Please click the OK button to confirm

z ADDR-HARD: It is an address you set in the dial switch. You can not modify it through software.

z ADDR-SOFT: You can set address via software. It is to say, you can use menu to modify dome address.

The value ranges from 0 to 255.

z BACK: Go back to the previous menu.

z EXIT: Log out system menu.

4.4.2 Display Setting

Move the cursor to DISPLAY SETUP and then click confirm button, you can go to the third submenu. Please

use the left/right button on the keyboard or in the speed dome terminal menu to set. After completed setup,

please click save button to save current setup.

z PRESET TITLE: Display dome preset title or not. Please use the left/right button on the keyboard or in

the speed dome terminal menu to set. You can go to Function Setup->Preset section to set

corresponding preset value and preset title.

z AZIMUTH DISP: Display dome current coordinates or not. Please use the left/right button on the

keyboard or in the speed dome terminal menu to set

z TIME DISP: Display dome system time or not. Please use the left/right button on the keyboard or in the

speed dome terminal menu to set.

z POSITION: Display the angel between the benchmark and then current location. Please use the

left/right button on the keyboard or in the speed dome terminal menu to set.

z ZOOM DISP: Display speed dome zoom speed or not. Please use the left/right button on the keyboard

or in the speed dome terminal menu to set.

z INSIDE TEMPERATURE: Display dome internal temperature or not. There are three options: ℃/F/Off.

Please use the left/right button on the keyboard or in the speed dome terminal menu to set.

z TITLE DISPLAY: Here you can set to display speed dome position information and etc. You can use the

speed dome control terminal to set the detailed title information. Please use the left/right button to set.

z BACK: Go back to the previous menu.

z EXIT: Log out system menu.

4.4.3 Camera Setting

Before the operation, please make sure your camera supports the corresponding function.

ADDR TYPE : HARD

ADDR-HARD : 001

ADDR-SOFT : 001

BACK

EXIT

PRESET TITLE ：ON

AZIMUTH DISP ：ON

TIME DISP ：OFF

POSITION ：OFF

ZOOM DISP ：OFF

INSIDE TEMP ：℃

TITLE DISP ：OFF

BACK

EXIT