Datasheet

preliminary preliminary
iC-MZ
DIFFERENTIAL HALL SWITCH
Rev A1, Page 7/11
HALL SENSOR POSITION
The position of the two Hall sensors S1 and S2 is
shown in Figure 5 (top view).
center of chip
2,0
0,14
S1 S2
x
y
Figure 5: Position of Hall sensors S1 and S2 in rela-
tion to the chip center (dimensions in mm)
The position tolerances of the chip within the DFN10
package are given in Figure 6.
S2
S1
center
of chip
|Dx| < 0.2
|DF| < 3°
|Dy| < 0.2
0.4 typ.
top view
side view
x
y
x
z
Figure 6: Maximum placement error of the chip (ex-
aggerated view) in a DFN10 package (di-
mensions in mm)
LINE DRIVER MODE
iC-MZ’s line driver mode is activated by TEST = high,
i.e. by a supply of VPA = 5V. Pins A and NA then func-
tion as inputs for line driver outputs D and ND. When
pins A and NA are connected up externally, D and ND
are triggered differentially.
D
ND
A
NA
NERR
TEST
GND2GND1
VPA
VB
4.5 ... 36 V
5 V
LINE
Figure 7: iC-MZ in line driver mode