Datasheet

MB3U, MB3U-I2C
BiSS TO PC-USB ADAPTER
Rev B3, Page 6/7
Button Description
Initialize Initializes BiSS bus after configurations are made
Read Output Reads in sensor data
Write File Saves sensor data to file
Figure 6: Middle section (one tab each per slave)
Button Description
Read Reg Loads register configuration from sensors to software GUI (hex)
Write Reg Transfers the displayed register configuration to sensors (hex)
Load File Loads register configuration from a file (hex)
Save File Saves register configuration to a file (hex)
Figure 7: Lower section (valid for all slaves)
Button Description
Read Reg see Middle Section
Write Reg see Middle Section
Load File see Middle Section
Save File see Middle Section
SENSSEL Mask for slave selection. For broadcast please select none
Reset SENSSEL Clears all SENSSEL checkboxes
Code BiSS command selection
Send BiSS Command Sends the chosen command to the selected slaves