user manual

////
// //
// RRSFALTR: //
// //
// IDCAMS JOB to rename the workspace data sets when installing //
// PTF UW9235 (multisystem node support) //
// //
// NOTE NOTE NOTE NOTE //
// Please note that this job should only be run when the //
// RACF subsystem address space has been taken down using the //
// procedure that is documented in the RACF publications. //
// NOTE NOTE NOTE NOTE //
// //
// Modify the JOB statement to fit your installation's //
// requirements before executing it. //
// //
// You will need to change the following: //
// //
// prefix - To the PREFIX name you specified //
// on the TARGET command for this node. //
// //
// nodename - Is the name given to the RRSF node via //
// the TARGET command that defined it. //
// //
// sysname - Is the CVTSNAME of the local system. //
// //
// local-node - Is the nodename associated with the //
// local node. //
// //
// remote-node - Is the nodename associated with the //
// remote node. //
// //
// local-lu - Is the LU name associated with the //
// local node or system. //
// //
// remote-lu - Is the LU name associated with the //
// remote node or system. //
// //
// //
// NOTE: THE REMAINING KEYWORDS SHOULD NOT BE ALTERED. //
// //
////
Figure 20 (Part 1 of 2). JCL to Rename the Workspace Data Sets
30 OS/390 V1R2.0 Security Server (RACF) Planning: Installation and Migration