Air Cleaner User Manual

About this book

This book describes the MQSeries commands (MQSC), which system operators and

administrators can use to manage queue managers on the following MQSeries

platforms:

v Compaq (DIGITAL) OpenVMS

v OS/2 Warp

v OS/390

v OS/400

v Tandem NSK

v UNIX operating systems

v Windows NT

The commands are described in alphabetic order in “Chapter 2. The MQSeries

commands” on page 9. At the start of each command description, the platforms on

which you can use the command are shown.

The term “UNIX systems” is used to denote the following UNIX operating

systems:

v MQSeries for AIX

v MQSeries for AT&T GIS UNIX

v MQSeries for Compaq Tru64 UNIX

v MQSeries for HP-UX

v MQSeries for SINIX and DC/OSx

v MQSeries for Sun Solaris (SPARC and Intel Platform Editions)

Who this book is for

This book is intended for system programmers, system administrators, and system

operators.

What you need to know to understand this book

To understand this book, you should be familiar with the system facilities for the

platform on which you are installing the MQSeries product.

If you are unfamiliar with the concepts of messaging and queuing, you should

read An Introduction to Messaging and Queuing.

How to use this book

For platforms other than OS/390, read those sections of the MQSeries

Administration Guide, System Management Guide,orSystem Administration book for

your platform that relate to the task you want to perform.

For OS/390, read the sections of the MQSeries for OS/390 System Administration

Guide, MQSeries for OS/390 System Setup Guide, or both that relate to the task you

want to perform.

These books are listed in “Bibliography” on page 303.

1. This platform has been renamed to NCR UNIX SVR4 MP-RAS, R3.0.

vii