Air Cleaner User Manual

Parameter descriptions
(channel-name)
The name of the channel to be reset. This is required.
CMDSCOPE
This parameter applies to OS/390 only and specifies how the command is
executed when the queue manager is a member of a queue-sharing group.
If CHLDISP is set to SHARED, CMDSCOPE must be blank or the local
queue manager.
‘’ The command is executed on the queue manager on which it was
entered. This is the default value.
qmgr-name
The command is executed on the queue manager you specify,
providing the queue manager is active within the queue-sharing
group.
You can specify a queue manager name only if you are using a
queue-sharing group environment and if the command server is
enabled.
CHLDISP
This parameter applies to OS/390 only and can take the values of:
v PRIVATE
v SHARED
In conjunction with the various values of the CMDSCOPE parameter, this
parameter controls two types of channel:
SHARED
A receiving channel is shared if it was started in response to an
inbound transmission directed to the queue-sharing group.
A sending channel is shared if its transmission queue has a
disposition of SHARED.
PRIVATE
A receiving channel is private if it was started in response to an
inbound transmission directed to the queue manager.
A sending channel is private if its transmission queue has a
disposition other than SHARED.
Note: This disposition is not related to the disposition set by the
disposition of the queue-sharing group of the channel definition.
The combination of the CHLDISP and CMDSCOPE parameters also
controls from which queue manager the channel is operated. The possible
options are:
v On the local queue manager where the command is issued.
v On another specific named queue manager in the group.
The various combinations of CHLDISP and CMDSCOPE are summarized
in Table 7 on page 238
RESET CHANNEL
Chapter 2. The MQSeries commands 237
|
|
|
|
|
||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|