Air Cleaner User Manual

Destination block
DEST
Limits the list to traces started for particular destinations. More than one
value can be specified, but do not use the same value twice. If no value is
specified, the list is not limited.
Possible values and their meanings are:
GTF The Generalized Trace Facility
RES A wrap-around table residing in the ECSA (extended common
service area)
SMF The System Management Facility
SRV A serviceability routine designed for IBM
®
for problem diagnosis
See “START TRACE” on page 265 for a list of allowed destinations for each
trace type.
Constraint block
CLASS(integer)
Limits the list to traces started for particular classes. See “START TRACE”
on page 265 for a list of allowed classes.
The default is CLASS(*), which does not limit the list.
RMID(integer)
Limits the list to traces started for particular resource managers. See
“START TRACE” on page 265 for a list of allowed resource manager
identifiers. Do not use this option with STAT.
The default is RMID(*), which does not limit the list.
Note: Information about RMID 231 might be inaccurate if the trace has
been altered using the ALTER TRACE command, or if the channel
initiator has been stopped.
TNO(integer)
Limits the list to particular traces, identified by their trace number (1 to
32). Up to 8 trace numbers can be used. If more than one number is used,
only one value for USERID can be used. The default is TNO(*), which does
not limit the list.
USERID(string)
Limits the list to traces started for particular user IDs. Up to 8 user IDs can
be used. If more than one user ID is used, only one value can be used for
TNO. Do not use this option with STAT. The default is USERID(*), which
does not limit the list.
DISPLAY TRACE
222
MQSeries MQSC Command Reference
|