Air Cleaner User Manual

CONNAME(connection-name)
The connection name for which status information is to be displayed, for
the specified channel or channels.
This parameter can be used to limit the number of sets of status
information that is displayed. If it is not specified, the display is not
limited in this way.
The value returned for CONNAME might not be the same as in the
channel definition, and might differ between the current channel status
and the saved channel status. (Using CONNAME for limiting the number
of sets of status is therefore not recommended.)
For example, if CONNAME:
v Is blank in the channel definition or, when using TCP, is in “host name”
format, the channel status value will have the resolved IP address.
v Includes the port number, again when using TCP, the current channel
status value will include the port number, but the saved channel status
value will not.
This value could also be the queue manager name, or queue-sharing group
name, of the remote system.
CURRENT
This is the default, and indicates that current status information as held by
the channel initiator for current channels only is to be displayed.
Both common and current-only status information can be requested for
current channels.
Short status information is not displayed if this parameter is specified.
SAVED
Specify this to cause saved status information for both current and inactive
channels to be displayed.
Only common status information can be displayed. Short and current-only
status information is not displayed for current channels if this parameter is
specified. On OS/390, the STATUS item is not displayed.
SHORT
This indicates that short status information and the STATUS item for
current channels only is to be displayed.
Other common status and current-only status information is not displayed
for current channels if this parameter is specified.
ALL Specify this to display all of the status information for each relevant
instance.
If SAVED is specified, this causes only common status information to be
displayed, not current-only status information.
If this parameter is specified, any parameters requesting specific status
information that are also specified have no effect; all of the information is
displayed.
The following information is always returned, for each set of status information:
v The channel name
v The transmission queue name (for sender and server channels)
v The connection name
DISPLAY CHSTATUS
162
MQSeries MQSC Command Reference
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|