Specifications

Mechanical Drawings
76 Thermal/Mechanical Design Guide
Figure B-25. Tower Reference Heatsink Assembly with TIM (Sheet 1 of 2)
13
4
5678
B C D
A
123
4
5678
B C D
A
2200 MISSION COLLEGE BLVD. P.O. BOX 58119 SANTA CLARA, CA 95052-8119
R
E32412 1 01
DWG. NO SHT. REV
SHEET 1 OF 2DO NOT SCALE DRAWINGSCALE: 1.500
01E32412D
REVDRAWING NUMBERSIZE
ASSEMBLY, HEAT SINK, THURLEY,
TOWER WITH TIM
TITLE
EASD / PTMI
DEPARTMENT
SEE NOTESSEE NOTES
FINISHMATERIAL DATEAPPROVED BY -- 12/14/07D. LLAPITAN DATECHECKED BY 12/14/07N. ULEN DATEDRAWN BY 12/14/07N. ULEN DATEDESIGNED BY
UNLESS OTHERWISE SPECIFIED INTERPRET DIMENSIONS AND TOLERANCES IN ACCORDANCE WITH ASME Y14.5-1994 DIMENSIONS ARE IN MILLIMETERS TOLERANCES: .X # 0.5 Angles # 1.0 $ .XX # 0.25 .XXX # 0.127
THIRD ANGLE PROJECTION
PARTS LIST
DESCRIPTIONPART NUMBERITEM NOQTY
ASSEMBLY, HEAT SINK, THURLEY, TOWER WITH TIME32412TOP HEAT SINK, THURLEY, TOWERD8500911 TIM, 0.250x35x35MM, HONEYWELL (SEE NOTE 9)PCM-45F21
REVISION HISTORY
ZONE REV DESCRIPTION DATE APPROVED
01 PRODUCTION RELEASE 12/14/07
THIS DRAWING CONTAINS INTEL CORPORAT ION CONFIDENTIAL INFORMATION. IT IS DISCLOSED IN CONFIDENCE AND ITS CONT ENTS MAY NOT BE DISCLOSED, REPRODUCED, DI SPLAYED OR MODIFIED, WITHOUT THE PRI OR WRITTEN CONSENT OF INTEL CORPORAT ION.
NOTES: 1. THIS DRAWING TO BE USED IN CORRELATION WITH SUPPLIED 3D DATABASE FILE. ALL DIMENSIONS AND TOLERANCES ON THIS DRAWING TAKE PRECEDENCE OVER SUPPLIED FILE. 2. PRIMARY DIMENSIONS STATED IN MILLIMETERS, [BRACKETED] DIMENSIONS STATED IN INCHES. CRITICAL TO FUNCTION DIMENSION. 3. ALL DIMENSION AND TOLERANCES PER ANSI Y14.5-1994. 4. REMOVE ALL BURRS, SHARP EDGES, GREASES, AND/OR SOLVENTS AFTER FINAL ASSEMBLY.
5 PART NUMBER AND TORQUE SPEC MARK.
PLACE PART NUMBER AND TORQUE SPEC IN THE ALLOWABLE AREA. BELOW PART NUMBER CALLOUT, PLACE THE FOLLOWING TEXT: "RECOMMENDED SCREW TORQUE: 8 IN-LBF" THE MARK CAN BE AN INK MARK, LASER MARK, PUNCH MARK OR ANY OTHER PERMANENT MARK THAT IS READABLE AT 1.0X MAGNIFICATION. 6. NA 7. NA
8 CRITICAL TO FUNCTION DIMENSION. 9 HONEYWELL PCM-45F THERMAL INTERFACE MATERIAL,
WITH CLEAR PROTECTIVE LINER REMOVABLE BY HAND. LINER ORIENTATION AND REMOVAL DIRECTION NON-CRITICAL. SEE PARTS LIST, ITEM 2. CLEAR PROTECTIVE LINER NOT SHOWN IN THIS VIEW.
2
1
5