Air Cleaner User Manual

The cfgcon command failed because of missing device support for either
the graphic adapter or standard I/O slot for ASCII monitors. You must
install the appropriate device support on the system from which the
backup tape was made, or install the appropriate device support on the
network boot server, reboot the server, and remake the network boot image
for the client.
c46 Normal installation processing during a no-prompt install
c47 Unable to create a PVID on a disk
This normally indicates a hard disk failure. If you are installing on the disk
for the first time, check and reformat, if necessary, the disk in diagnostics
and retry the installation.
c48 Prompting user for input during a no-prompt install
An error has occurred during a no-prompt installation. This LED is used to
alert the user to the message displayed on the system console. The
installation process has defaulted to prompt mode. Press Enter on the
console to re-display the specific error message, then use the normal
installation menus on the screen to correct the problem and begin the
installation.
c50 The rootvg volume group is being created during a no-prompt install
c52 Changing from boot (RAM) to restored rootvg file systems during a
no-prompt install
200 The system key is in secure mode when booting
If booting from network, turn the key to service mode and press the reset
key. If booting from tape, power off, turn the key to service, and power on.
260, 261 or 262
The BOOTP menus have been invoked
The system is to be booted from the network and the BOOTP menus have
been invoked. If they are not displayed, press Enter on the console.
510 Configuring base system devices during a tape boot
511 then blank screen
Console configured but messages cannot be displayed
The cfgcon successfully configured a system console device; however, the
console messages are not displayed because of missing or incorrect device
support for the graphic adapter. You must install the appropriate device
support on the system from which the backup tape was made, or install
the appropriate device support on the network boot server, reboot the
server, and remake the network boot image for the client.
512 Configuring additional system devices during a tape boot
513 Restoring installation files from tape during a tape boot
600 Starting a network boot
602 Configuring base system devices during a network boot
603 Configuration of base system devices failed during a network boot
There is likely device support missing from the boot image which is
required to support the client system’s bus, I/O or disk hardware. You
need to install the appropriate device support on the server system, reboot
the server, and remake the network boot image for the client.
C-2 IBM Tivoli Storage Manager for System Backup and Recovery: Installation and User’s Guide