Air Cleaner User Manual

Appendix C. LEDS
This chapter contains a list of the system LED codes that might appear when you
boot or install from a SysBack System Backup. Many of the LED codes are for
information only and usually occur when there is no system console available;
others indicate an error in the boot or installation process.
Many of the LED codes appear only during a no-prompt installation. This is because
there may not be a system console attached and the LED is used to provide
information to the user on the progress of the installation, or because an error
occurred that requires user intervention.
The LED codes below are those that are provided by SysBack. Any other codes
that appear are not part of the SysBack product but normally represent a system
software or hardware problem. If the LED code is not listed here, refer to your AIX
software diagnostics documentation for details.
000 Failed to identify the system type during a tape boot
The bootinfo -B command failed due to device support missing from the
boot image that is required to support the client system’s hardware. The
problem usually is caused by missing SCSI device support. You need to
recreate the boot tape from a system containing all device support required
for the system to be installed.
c04 An unrecoverable error occurred during a no-prompt installation
A message has been displayed on the system console. Press Enter on the
console to display the detailed error message.
c06 Failed to identify the system type during a network boot
The bootinfo -B command failed due to device support missing from the
boot image that is required to support the client system’s hardware. The
boot server is likely missing device support for either the token-ring,
ethernet or FDDI adapter. You need to install the appropriate device
support on the server system, reboot the server, and remake the network
boot image for the client.
c21 Unable to configure logical network device during a network boot
The ifconfig command failed. Report the problem to your network service
organization.
c31 Prompting user to select a system console
c32 User selected a graphical display as a console device
c33 User selected an ASCII display as a console device
c40 Installation data is being extracted from the install media during a
no-prompt install
c43 Error restoring the AIX install programs during a tape boot
Either the tape media is defective, the tape drive is defective, or the boot
tape is incomplete. Create another boot tape and try booting from tape
again.
c45 Failed to configure a system console
© Copyright IBM Corp. 2002,2003 C-1