Air Cleaner User Manual

3. Turn on the system or press the yellow button twice.
4. Continue with “Completing the Boot Process” on page B-4
.
Booting from a network boot server
Use these instructions to obtain the BOOTP screen:
1. Turn the system key to the SECURE position.
2. Turn on the power to the system. After a short sequence of numbers, the LED
displays 200.
3. Turn the key to the SERVICE position and press the yellow reset button once.
4. If the LED value displays 260, 261, or 262, and the BOOTP Main menu is
displayed on the screen, continue with “Initiating the Network Boot” on
page B-4.
If the above instructions did not work, you need to boot from an IPLROM
Emulation Diskette:
1. Insert the IPLROM Emulation Diskette.
2. Turn the system key to the SERVICE position.
3. Turn on the power to the system or press the yellow reset button twice.
4. Continue with “Initiating the Network Boot” on page B-4.
Microchannel-based RISC System/6000 SMP (multiprocessor)
You can boot a microchannel-based RISC System/6000 system in one of two ways:
from a SysBack system backup tape or from a network boot server.
Booting from a SysBack system backup tape
1. Insert the system backup tape.
2. Power off the system.
3. Turn the system key to the SERVICE position.
4. Press Enter until the “>” prompt appears.
5. Type sbb and press Enter to view the STAND-BY.
6. Select option 1, Set Flags.
7. Select option 2, Autoservice IPL. Make sure this value is set to “enable”.Ifso,
press “n”. If it is currently set to “disable”, press “y” to change it.
8. Select option 6, Fast IPL. Make sure this value is set to “enable.” If it is, press
“n”. If it is currently set to “disable,” select “y” to change it.
9. Type x to return to the “>” prompt.
10. Type x again to clear the screen.
11. Power on the system.
12. Continue with “Completing the Boot Process” on page B-4.
Booting from a network boot server
1. Power off the system.
2. Turn the system key to the SERVICE position.
3. Press Enter until the “>” prompt appears.
4. Type sbb and press Enter to view the STAND-BY.
5. Select option 1, Set Flags.
6. Select option 2, Autoservice IPL. Make sure this value is set to “enable.” If it
is, press “n”. If it is currently set to “disable,” press “y” to change it.
B-2 IBM Tivoli Storage Manager for System Backup and Recovery: Installation and User’s Guide