Air Cleaner User Manual

sbtsmnetcfg
Purpose
This command sets the TSM Network Client Install Defaults. For more
informational this topic, please refer to “Configuring Network Boot Options for a
TSM Bare Metal Recovery” on page 15-18
 sbtsmnetcfg -h
-n ″tsmnode″
-d ″networkdev″
-r ″ringspeed″
-E ″entif″
-e ″entcon″
-p “tsmport”
-P “tsmpasswd”
-s “serverIP”
-g “gatewayIP”
-S “submask”

Flags
-h ″hostname″
Specify the hostname of the system which was configured as a SysBack
network boot client. The value for this field was populated by the input in the
previous menu.
Note: The SysBack network boot client definition is based on the hostname of
the client system. This may, or may not be, the same as the TSM client
node name.
This flag is required.
-n ″tsmnode″
Specify the TSM node name that will be used to connect to the TSM server for
bare metal recovery. This flag is required.
-d ″networkdev″
Specify the network device name to use for communications with the TSM
server. For example: ent0. This flag is optional.
-r ″ringspeed″
Specify the correct token-ring speed when a token-ring device specified in the
TSM Network Device field. This field is optional.
--E ″entif″
Specify either type of ethernet interface when an ethernet device is specified in
the TSM Network Device Name field. For example: IEEE 802.3 This flag is
optional.
-e ″entcon″
Specify the connection type for the ethernet interface when an ethernet device
is specified in the TSM Network Device Name field. For example: BNC. This
flag is optional.
-p ″tsmport″
Specify the TSM server port number that should be used to connect to the
TSM server for bare metal recovery. This flag is optional.
Appendix A. Commands A-83