Air Cleaner User Manual

sbspotcust
Purpose
Installs SysBack into a NIM SPOT resource.
Syntax
 sbspotcust
-d ″devname″
″dirname″
-l ″lppsource name″
-F
-n ″spot name″
-q

Description
When performing a NIM Resource Network Boot, SysBack must be installed into
the NIM SPOT resource in order for the SysBack programs to be available during
a network boot. The sbspotcust command reads the installation filesets from the
specified input device or directory, copies them into the specified NIM
LPPSOURCE directory, and installs them into the NIM SPOT from the NIM
LPPSOURCE directory.
Note: You must run this command before adding a NIM Resource Network Boot
client to ensure that the client’s boot image contains the SysBack programs.
If you install or update the SysBack filesets contained in the NIM SPOT
resource after the network boot client is added, you must update the
network boot image used by the client using the mksbnetboot command.
Flags
-d “devname | dirname”
Specifies the input device name or directory name that contains the SysBack
filesets.
-F Indicates to overwrite the same or newer version of SysBack in the NIM SPOT
resource with the version contained on the installation media.
-l “lppsource name”
Specifies the NIM LPPSOURCE name to which the filesets will be copied.
-n “spot name”
Specifies the NIM SPOT name to which the filesets will be installed.
-q
Checks the specified spot to determine if a valid level of SysBack is installed.
The -n flag is required.
Examples
1. To install SysBack to the NIM SPOT resource called “spot_433” from the
/dev/cd0 device through the NIM LPPSOURCE called “lppsource_433”, type:
sbspotcust -d /dev/cd0 -n spot_433 -l lppsource_433
2. To query the level of the spot in spot_433, type:
Appendix A. Commands A-77