Air Cleaner User Manual

sbspboot
Purpose
Initiates a NIM Resource Network Boot of an SP node.
Syntax
 sbspboot
-d ″host″
-n ″spot name″
-c ″lppsource name″
-c ″display″

Description
The sbspboot command is used to initiate a NIM Resource Network Boot of an SP
node. Use this command instead of the Classic Network Boot method to ensure
that the proper SP and PSSP specific scripts are executed. For more information
about this command, see Chapter 13, “Network Boot/Installation Configuration”,
on page 13-1.
This command must be initiated from the SP Control workstation.
The specified NIM SPOT and NIM LPPSOURCE entries must be the same as
those specified when the client was added for network boot using the
mksbnetboot command.
Flags
-h “host”
Specifies the hostname of the SP node to be booted.
-n “spot name”
Specifies the NIM SPOT resource to be used for the network boot process.
-l “lppsource name”
Specifies the NIM LPPSOURCE resource to be used for post-installation
processing.
-d “display”
Specifies the hostname where a console window will be displayed during a
prompted installation.
Examples
To initiate a network boot of an SP node called “bcn1e” using the NIM SPOT
“spot_aix433” and the NIM LPPSOURCE “lppsource_aix433” and to open a
console window on the host “lasher,” type:
sbspboot -h bcn1e -n spot_ais433 -l lppsource_aix433 -d lasher:0
Related Information
The mksbnetboot and sbspotcust commands.
A-76 IBM Tivoli Storage Manager for System Backup and Recovery: Installation and User’s Guide