Air Cleaner User Manual

-N “y|n”
Indicates whether or not to remove network specific information required to
configure the host to the network. This option is useful when the machine
installed was cloned from a backup image of a machine that is still present on
the network. The default is “n” or no.
Note: This option has no effect when cloning images between partitions of the
same LPAR Capable machine.
-S “ip address”
The address of the installation server. If the backup media from which the
client will be installed exists on a different server than the network boot server,
enter the IP address of the installation server here.
-g “ip address”
The IP address of the gateway, if the client will be installed from a different
server than the network boot server, and a different gateway address is
required to reach the installation server.
-n “device name”
The network device name, if the client will be installed using a different
network adapter than it was booted from. The name should be in the format of
“entX”,or“tok0”.
-s “subnet mask”
The subnet mask required for the network adapter used to contact the
installation server, if the client will be installed from a different network
adapter than it was booted from.
-T “value”
The token ring speed of the network for network installations over a token
ring interface. If the boot server is also the installation server, you do not need
to set this option. If the installation server uses a different network adapter,
and the network adapter is token ring, specify the correct token ring speed.
-E “en|et”
The ethernet interface used for network installations over an ethernet interface.
If the boot server is also the installation server, you do not need to set this
option. If the installation server uses a different network adapter, and the
network adapter is ethernet, specify the correct interface.
-e “bnc | dix”
Specifies the ethernet connection type for network installation over an ethernet
interface. If the boot server is also the installation server, you do not need to
set this option. If the installation server uses a different network adapter, and
the network adapter is ethernet, specify the correct connection.
-p “post install script file”
The fully-qualified path and name of a post-install script to run at the end of
installation. The file must exist on the installation server and be readable by
any user. For more information about post-install scripts, see Appendix D,
“Creating Scripts for Customizing the System Backup and Install Process”,on
page D-1.
-L “LVM information file”
The fully-qualified path and name of an LVM information file. The LVM
information file must contain information that is compatible with the client.
The file must exist on the installation server and be readable by any user. For
more information about LVM information files, see Chapter 16, “Utilities”,on
page 16-1.
A-8 IBM Tivoli Storage Manager for System Backup and Recovery: Installation and User’s Guide