Air Cleaner User Manual

Console Device Name
To prevent the prompt shown prior to the installation menus that
determines which console to be used for the installation, you must
enter the name of the console device here. This may be either an LFT
(graphical display) or TTY (ascii display) device. Examples are
/dev/1ft0 or /dev/tty0. If an LFT device exists on the client, it may
also be selected by typing /dev/console. The default is none/blank.
Note: You must select the display, even for a promptless install. You
will then be able to receive any error or warning messages and
allow for prompts if the default information provided is
insufficient to complete the install.
Console Terminal Type (if ascii)
If the console device is an ascii terminal, or tty device, you must select
a specific terminal type. This ensures that installation menus, if
required, are displayed with the correct terminal emulation. You may
enter the device type or press F4 to display a list of all terminal types
defined on the server and select from the list. Examples of common
terminal types are “ibm3151”, “tvi925”, and “vt100.” The default is
none/blank.
Non-rootvg Volume Group Option
The default is set at Restore Rootvg Only. The following is a description
of each option.
Restore Rootvg Only
Only the rootvg volume group will be created and restored
from the media, even if there are other volume groups defined
in the backup. At the end of the install only the rootvg will be
defined.
Restore All VGs
All volume groups that are included on the backup media will
be created and restored. Volume groups that were defined on
the original system but whose data was not included in the
backup will be created but no data will be restored.
Import Non-Rootvgs
The rootvg volume group will be created and restored. All
other volume groups will be imported from disks on the client.
This option assumes that non-rootvg volume groups already
exist on the client. You typically use this option when restoring
the rootvg volume group after a system failure and no other
volume groups have been affected.
Restore Device or File
The options which appear are those made available using Add or
Change Client Host Access to this Server under the Remote Services
menu. You must select an option from this list to prevent being
prompted for an install device or file during the installation process.
The default is none/blank. For more information on defining these
resource, see Chapter 8, “Remote Services”, on page 8-1.
Backup Sequence Number (if tape)
If the client is to be installed from tape, and the System Backup to be
installed is not the first System Backup on the tape, enter the Backup
16-14 IBM Tivoli Storage Manager for System Backup and Recovery: Installation and User’s Guide