Air Cleaner User Manual

is included in the boot image. It is the file that is used during the boot and
installation process that processes these specifications.
This is similar to the Set Network Install Client Defaults menu for network boot
or installation processes.
To set the CD/DVD Boot Defaults:
Note: You may also access this same menu by using the following SMIT paths:
smitty sysback Sysback Program Defaults
Change Sysback Program Defaults Change Sysback Tape
Defaults Change Sysback CD/DVD Boot Defaults
Set Network Install Defaults
1. From the Utilities menu, select Change SysBack CD/DVD Boot Defaults.
Note: From a command line, type smit sb_cfginstcd.
2. The following screen is displayed:
The fields have the following definitions:
Perform No-Prompt Installation?
Perform No-Prompt Installation specifies the client to be installed will
be prompted. If this field is set to no, the installation menus will appear
after a network boot. Otherwise, the install will take place after the
network boot without prompting the user if all the required
information has been provided. The default is no.
Change Sysback CD/DVD Boot Defaults
Type or select values in entry fields.
Press Enter AFTER making all desired changes.
[Entry Fields]
Perform no-prompt installation yes +
THE FOLLOWING ARE REQUIRED FOR NOPROMPT INSTALL
Console Device Name [/dev/1ft] +
Console Terminal Type (if ascii) [] +
Non-rootvg Volume Group Option Restore all VGs +
Restore Device (if different than boot device) [] +
Backup Sequence Number (if tape) [2] #
Remove Sysback from foreign client after install? yes +
Remove Network Config from foreign client? yes +
Install Addtional Device Driver Support? None +
Software Install Device [] +
Debug Logging? yes +
THE FOLLOWING WILL OVERRIDE INSTALL FILES ON
THE BACKUP MEDIA:
Post-Install Script []
LVM Information File []
F1=Help F2=Refresh F3=Cancel F4=List
F5=Reset F6=Command F7=Edit F8=Image
F9=Shell F10=Exit Enter=Do
Figure 16-5. The Change SysBack CD/DVD Boot Defaults Menu
Chapter 16. Utilities 16-13