Air Cleaner User Manual

Non-rootvg Volume Group Option
The default is set at Restore Rootvg Only. The following is a description
of each option.
Restore Rootvg Only
Only the rootvg volume group will be created and restored
from the media, even if there are other volume groups defined
in the backup. At the end of the install only the rootvg will be
defined.
Restore All VGs
All volume groups that are included on the backup media will
be created and restored. Volume groups that were defined on
the original system but whose data was not included in the
backup will be created but no data will be restored.
Import Non-Rootvgs
The rootvg volume group will be created and restored. All
other volume groups will be imported from disks on the client.
This option assumes that non-rootvg volume groups already
exist on the client. You typically use this option when restoring
the rootvg volume group after a system failure and no other
volume groups have been affected.
Restore Device or File
The options which appear are those made available using Add or
Change Client Host Access to this Server under the Remote Services
menu. You must select an option from this list to prevent being
prompted for an install device or file during the installation process.
The default is none/blank. For more information on defining these
resource, see Chapter 8, “Remote Services”, on page 8-1.
Backup Sequence Number (if tape)
If the client is to be installed from tape, and the System Backup to be
installed is not the first System Backup on the tape, enter the Backup
Sequence Number. This number must be between 1 and the total
number of System Backups on the tape media. The default is
none/blank.
Remove Sysback from Foreign Client After Install
This yes or no field indicates whether to remove the SysBack program
from the system after an installation. This is useful when the user has
not purchased a license for the client that will be installed. The default
is no.
Remove Network Congfig from Foreign Client
This yes or no field indicates whether to remove network specific
information required to configure the host to the network. This option
is useful when the machine installed was cloned from a backup image
of a machine that is still present on the network. The default is no.
Install Additional Device Driver Support?
This option tells SysBack how much to instal of what is contained in
the media in the location specified by the Software Install Device
option. The two options are:
Minimum
Selecting this option will install only those device support
filesets identified by AIX when the system was booted. This
information is obtained from the file /tmp/devices.pkgs which
Chapter 16. Utilities 16-11