Air Cleaner User Manual

installed is not the first system backup on the tape, enter the backup
sequence number. This number must be between 1 and the total
number of system backups on the tape media. The default is
“none/blank”.
Remove SysBack from Foreign Client After Install
Indicates whether or not to remove the SysBack program from the
system after installation. Choose “yes” when you have not purchased a
license for the client that will be installed. The default is “no”.
Note: If you are installing a backup on an LPAR capable machine, that
was made from another partition in that same machine, this
prompt will not occur. However, if you would like to remove the
product from the new partition, you may configure SysBack to
do so using the Utilities menu option described in “Remove
SysBack Programs After Install” on page 12-15.
Remove Network Configuration from Foreign Client
Indicates whether or not to remove network specific information
required to configure the host to the network. Choose “yes” when the
machine installed was cloned from a backup image of a machine that is
still present on the network. The default is “no”.
Note: If you are installing a backup on an LPAR capable machine, that
was made from another partition in that same machine, this
prompt will not occur. However, if you would like to remove the
product from the new partition, you may configure SysBack to
do so using the Utilities menu option described in “Removing
the Network Configuration” on page 12-11.
Install Server IP Address
The address of the installation server. If the boot server is also the
installation server, do not change this option. If the backup media from
which the client is installed exists on a different server, enter the IP
address of the installation server. The default is the boot server’sIP
address.
Gateway Address
The address of the boot server. If the boot server is also the installation
server, do not change this option. If the client is installed from server
other than the network boot server and a different gateway address is
required to reach the installation server, enter that gateway IP address.
The default is the boot server’s gateway address.
Network Device Name
If the client is installed using a network adapter different than it was
booted from, enter the device name of the network adapter here. The
default is “none/blank”.
Subnet Mask
If the client is installed using a network different than it was booted
from, enter the subnet mask, if any, required for the network adapter to
contact the installation server. The default is “none/blank”.
Token-Ring Speed (if applicable)
If the installation server uses a different network adapter, and the
network adapter is token-ring, select the correct token-ring speed. If the
boot server is also the installation server, do not set this option. The
default is “none/blank”.
13-8 IBM Tivoli Storage Manager for System Backup and Recovery: Installation and User’s Guide