Air Cleaner User Manual

If you selected an FDDI adapter, you receive options similar to those above, except
that the token ring speed option is not displayed. There are no options specific to
the FDDI adapter.
If you booted from a network boot server, the addresses and subnet mask used to
boot the system are displayed. Otherwise, if the boot media was created on a
system previously network-installed using SysBack, the prior network installation
settings are displayed.
To change the client, server or gateway IP address,orthesubnet mask, highlight
the line you want to change and enter the new value.
Note: If the client and the network install server are on the same subnet, and the
client does not have to pass through a network gateway in order to reach
the server, it is recommended that you re-enter the Server Addressinthe
Gateway Address field. If the client and the network install server are on
different subnets, you would enter the network gateway address in the
Gateway Address field.
To change the ethernet interface, ethernet connection type or token ring speed,
highlight the desired selection and press Enter.
When all selections are complete, press Esc to return to the previous menu.
If you are installing over the network using a TSM virtual device and need to
access a different machine as your network install server, you should select the
tsmdev device entry and not the network adapter used to access that machine. For
more information on completing these menus for a TSM network install, please
refer “Bare Metal Recovery and System Reinstallation from a TSM Server” on
page 15-21 for detailed instructions.
Important note: For token ring networks, be certain to select the correct token ring
speed. Not doing so could cause disruption on the entire network
when the token ring adapter is configured.
+----------------------------------------------------------+
| Change Network Settings |
+----------------------------------------------------------+
Client IP Address 192.168.1.58
Server IP Address 192.168.1.55
Gateway IP Address 192.168.1.55
Subnet Mask 255.255.255.0
Token-ring Speed:
4 Megabits
==> 16 Megabits
Network Adapter: tok0 [inactive]
+------------------------------------------------------------------------------+
| Enter the IP address by which the server refers to this host in the format |
| "111.222.333.444". You need not include leading zeros. |
+------------------------------------------------------------------------------+
| Use ARROWS or TAB to move or INS/DEL to edit. Press ESC to return. |
+------------------------------------------------------------------------------+
Figure 12-5. The Change Network Settings Options for a Token Ring Adapter
12-6 IBM Tivoli Storage Manager for System Backup and Recovery: Installation and User’s Guide