Air Cleaner User Manual

The following is a description of each field:
Install Option
Indicates whether the selected volume group should be created, imported
or ignored:
Create Enter “c” to completely recreate the volume group on the specified
disks. If installing the system, all logical volume and filesystem
data are restored if the data was included on the backup media.
Import
Enter “i” to import the volume group from the physical volumes
currently selected for the volume group. If so, the selected physical
volumes must currently contain the volume group information.
Delete Enter “d” if you do not want to create the selected volume group.
If set to this value, the volume group will be ignored and the
physical volumes currently assigned to this volume group can be
assigned to another volume group. Any existing data on these
volumes will not be destroyed. Therefore, should you decide later
to use that data, you may import and vary on the volume group
that was previously created on those disks provided that you have
not reassigned them to other volume groups.
This option is not available for the rootvg volume group.
Auto Varyon at System Startup?
Press “y” or “n” to indicate whether the volume group should be
automatically varied on at system startup. This option cannot be changed
for the rootvg volume group.
Physical Partition Size (MB)
Enter a physical partition size in megabytes. Valid options are 2, 4, 8, 16,
32, and 64, 128, 256, 512, and 1024.
+----------------------------------------------------------+
| Change "adsmvg" Volume Group Attributes |
+----------------------------------------------------------+
Attribute Value
Install Option Create
Auto Varyon at System Startup? yes
Physical Partition Size (MB) 8
Quorum Checking? yes
Copies Not Set
Concurrent-capable? no
Auto-concurrent Varyon? ***
Big Enabled Volume Group? no
Factor Size? 1
Hot Spare? no
Logical Track Group Size? 128
Auto-sync? no
Filesystem Type? Not Set
+------------------------------------------------------------------------------+
| Type "c" to Create, "i" to Import, or "d" to Delete (ignore). |
| "Create" will create the volume group and restore data (if on the backup). |
+------------------------------------------------------------------------------+
| Use UP/DOWN ARROW or Tab to highlight option to change. Press ESC to return. |
+------------------------------------------------------------------------------+
Figure 11-5. The Change Volume Group Attributes Menu
Chapter 11. Changing the Volume Group, Logical Volume and Filesystem Attributes 11-5