Hub/Switch Installation Guide

Appendix F Additional SSM Information
532 September 2002 HPSS Installation Guide
Release 4.5, Revision 2
◆ SSM work areas for the new user are created. These work areas are /opt/hpss/sammi/
ssmuser/<user> (where <user> is the actual ID of the new user), and
/opt/hpss/sammi/ssmuser/<user>/mapfiles.
◆ A template Sammi configuration file (ssm_console.dat) is copied to the new user’s
work area and modified to be user-specific. This involves editing the console ID
number, process hostnames, and the RPC addresses and version numbers for the two
vital Sammi processes.
◆ An X resources file named SAMMI is copied to the user’s home directory.
F.6 Non-standard SSM Configurations
AnumberofSSMconfigurations arepossiblethatdonotgetsetupbythedefaultHPSSinstallation
or SSM user configuration. Using these configurations involves performing some procedures
manually, instead of accepting the automated defaults. The information below can help in setting
up these non-standard configurations.
You should not attempt to set up non-standard configurations unless you are familiar with how
SSM works,andonly whenthere isareal needtodoso. Theseconfigurations aremore difficult to
set up and maintain, and most of them will have negative impacts on SSM performance.
Multiple Data Servers. The defaults assume only one SSM Data Server, running on the same host
as the other SSM components. You may want multiple Data Servers, with some or all of them
running on different hosts. For each SSM user with a non-default Data Server, you must edit the
user’s Sammi configuration file (/opt/hpss/sammi/ssmuser/<user>/ssm_console.dat). Near the
bottomofthisfileisalogical_serverlineforssm_ds,whichistheDataServer.EdittheRPCaddress
and the hostname on this line as appropriate for the non-default Data Server. Note that all
concurrentlyrunningData Serversmusthave uniqueRPCaddresses(althoughit isnotmandatory
that they run on different hosts). Make sure that any RPC addresses you select are not being used
by any other processes on that host. Also note that multiple Data Servers must have unique CDS
entries, as is true for any HPSS server.
If any of the above changes are made, the user must create a customized version of the start_ssm
script which reflects the non-default RPC address for the Data Server and the non-default CDS
names. If the Data Server and System Manager are to be executed on different hosts, invoke the
start_ssm script with the -s option (to start the System Manager only) or -d option (to start up the
Data Server only) on the appropriate host. If more than one Data Server is to be run on the same
host, the logic in the script that disallows duplicate data servers must be removed.
Non-standard Sammi Runtime. The defaults assume that all SSM users are running Sammion the
samehostwhereyouexecutedthehpssuserscript.IfyoursitehasmultipleSammilicenses,anSSM
usermayberunningSammionaworkstationremotefromthemainSSMprocesses.ForanySammi
console ID not on the default host, you must edit the API configuration file (for that console) to
correct the hostname for the two Sammi processes. You must also edit the user’s Sammi
configurationfile(ssm_console.dat)tochangethesametwohostnames.Youmustthentransferthe
user’s Sammiwork area (see above) fromthe defaulthost tothe actualhost.Finally, you will likely
have to provide the user a customized copy of the start_ssm_session script to deal with the non-
standard Sammi runtime.