Hub/Switch Installation Guide

Chapter 6 HPSS Configuration
HPSS Installation Guide September 2002 373
Release 4.5, Revision 2
6.8.13 Configure the PVR Specific Information
The PVR specific configuration entry can be created using the PVR Server Configuration window.
After the configuration entry is created, it can be viewed, updated, or deleted through the same
window.
If you are configuring a PVR for StorageTek, IBM 3494/3495/3584, or ADIC AML; before
proceeding with PVR configuration you should read the PVR-specific section (Section 6.8.13.4:
StorageTekPVRandRAITPVRInformationonpage389,Section6.8.13.3:IBM3494/3495PVR
Information on page 388, Section 6.8.13.2: LTO PVR Information on page 387, and Section
6.8.13.5:ADIC AutomaticMedia LibraryStorage SystemsInformationonpage392).Thesesectionsprovide
additional vendor-specific advice on PVR/robot configuration.
The STK RAIT PVR cannot be supported at this time since STK has not yet made RAIT
generally available.
From the HPSSHealth and Status window (shownin Figure 6-1), clickon the Admin menu, select
the Configure HPSS option and click on the Servers option. The HPSS Servers window will be
displayed as shown in Figure 6-5.
To add a new specific configuration, select the PVR Server entry and click on the Type-specific...
button from the Configuration button group on the HPSS Servers window. The PVR Server
Configurationwindowwillbe displayed(as showninfigures 6-33through 6-39)dependingon the
selected PVR type) with default values. If the default data is not desired,changethefieldswiththe
desired values. Click on the Add button to create the configuration entry.
To updatean existing configuration,select the PVR Serverentry on the HPSSServers window and
click on the Type-specific... button from the Configuration button group. The PVR Server
Configuration window will be displayed with the configured data. After modifying the
configuration, click on the Update button to write the changes to the appropriate SFS file.
To delete an existing configuration, select the PVR Server entry on the HPSS Servers window and
click on the Type-specific... button from the Configuration button group. The PVR Server
Configuration window will be displayed with the configured data. Click on the Delete button to
delete the specific configuration entry.
Refertothe window’shelpfile formoreinformationon the individualfields andbuttonsaswell as
the supported operations available from the window.