Hub/Switch Installation Guide

Chapter 6 HPSS Configuration
370 September 2002 HPSS Installation Guide
Release 4.5, Revision 2
6.8.12 Configure the PVL Specific Information
The PVL specific configuration entry can be created using the PVL Server Configuration window.
After the configuration entry is created, it can be viewed, updated or deleted through the same
window.
From the HPSSHealth and Status window (shownin Figure 6-1), clickon the Admin menu, select
the Configure HPSS option and click on the Servers option. The HPSS Servers window will be
displayed as shown in Figure 6-5.
Maximum Request Queue
Size
The maximum number of
requests to queue until a
request thread becomes
available. If this queue
fills, no more requests will
be processed for this
particular Non-DCE client
until there is more room in
the queue.
Any positive 32-bit integer value. 20
Authentication Mode These are the NDAPI
client authentication
mechanisms supported by
the gateway.
DCE and/or Kerberos or None DCE
Advice: The NDAPI Client Library provides a means for a client to set the type of
authentication mechanism it wishes to use. By default the NDAPI supports the
DCE and None mechanisms (NDAPI ClientLibrary andGatewaycanberebuiltto
also support Kerberos authentication). During initial connection the client may
request authentication using one of supported mechanism. If the gateway supports
this mechanismandtheclient provides the correctauthentication material,then the
clientisgrantedaccess toHPSS asthe presentedidentity.Careshouldbe takewhen
settingthisfield,ifneitherDCEorKerberosisspecified,thenNDAPIclientwillnot
be required to authenticate themselves.
DCE Encryption Key A key used to encrypt the
DCE user name and
password passed between
the NDAPI client and
gateway during the initial
connection.
This value can only be changed by
clicking on the Generate New Key
button.
0
Advice:Thiskeyshouldalwaysbe setifusing DCEauthentication.The valueofthis
key should be placed in the NDAPI Client Library encryption key file (see Section
7.2: Non-DCE ClientAPIConfigurationonpage415 fordetails onconfiguring the
NDAPI Client Library).
Table 6-29 Non-DCE Client Gateway Configuration Variables
Display Field Name Description Acceptable Values
Default
Value