Hub/Switch Installation Guide

Chapter 6 HPSS Configuration
298 September 2002 HPSS Installation Guide
Release 4.5, Revision 2
• Event—defines an informational message (e.g., subsystem initializing, subsystem
terminating). Typically, the policy would be to send events to both the log and to SSM for
displaying in the HPSS Alarms and Events window (Figure 1-5 on page 38 of the HPSS
Management Guide).
• Status - defines a status message to be output in a pop-up window or to the log. Typically,
the policy would be to not send these messages to the log or to the screen. Currently, this
message type is only used by the Accounting.
The following log message types can be specified for logging:
• Debug—defines a lower-level error message. For troubleshooting, these messages are
important record types because they provide more detailed information about the root
cause of an error. Typically, the policy would be to not send these messages to the log.
• Request—used to log the fact that a particular client or server request is being processed.
Typically, the policy would be to send these messages to the log.
• Security—used to log security related events (e.g., authorization failures). Typically, the
policy would be to not send these messages to the log.
• Accounting—used to log accounting information. This record type is not currently used.
• Trace—used to trace any type of entry/exit processing flows. Typically, the policy would
be to not send these messages to the log.
The Logging Policy can be created using the HPSS Logging Policies window. After the Logging
Policy is created, it can be viewed, updated, or deleted through the same window.
Fromthe HPSSServerswindow (shown in Figure6-5), selectaserver and click on the Log Policy...
button.
The LoggingPolicywindowwill bedisplayed asshown inFigure6-11. For configuredserver, click
on the Name of Server to Which Policy Applies popup button and select the desired server. The
Logging Policy for a configured server may also be accessed from the HPSS Servers window, and
from the Basic Server Configuration window for that server. With either of the last two methods,
the Logging Policy window opens with the server name already filled in.
For non-configured servers or utilities, simply type a server name into the Name of Server to
Which Policy Applies field, and press Enter.
Refertothe window’shelpfile formoreinformationon the individualfields and buttonsas wellas
the supported operations available from the window.
Once a LoggingPolicyiscreated or updated, it will notbeineffect until its associated Log Client is
startedor reinitialized.The LogClientassociated witha particularpolicyis theonewhich executes
on the same host as the server to which the policy applies. The Reinitialize button on the HPSS
Servers window(Figure 1-1 onpage 20 of theHPSS Management Guide) canbe used toreinitialize a
running Log Client.