- Roland Engraveing Machine User's Manual

52
Chapter 3 - Preparations
3-5. Cutter Installation Method 4 (End Mill)
Installing an End Mill
1. Installing the Collet and End Mill
1
Open the spindle cover.
2
Insert the end mill into the optionally available
end-mill collet.
3
Insert the end mill and collet from below. While
gently holding the collet in place, turn the
spindle by hand until it is finger-tight.
4
Use the included wrench to tighten the collet.
The correct tightening torque is 32 kgf-cm.
20 to 25 mm (3/4 to 1 in.)
1.
3.
2.
While installing the cutter, do not allow the operation panel to be touched inadvertently. When using the
operation panel, keep hands away from moving areas of the machine. Unintended operation of the ma-
chine may lead to danger of becoming caught.
Do not touch the tip of the cutter. Doing so may result in injury.
Securely fasten the cutter and workpiece in place. Otherwise they may come loose during cutting, resulting
in injury.